NETWORK GATEWAY ECU > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE FRONT DOOR SCUFF PLATE RH


    B111783

  1. Disengage the 4 claws and 2 clips, and remove the rear door scuff plate.

  1. Disconnect the connector. (w/ illumination scuff plate)



3. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH

HINT:
Use the same procedures for the RH side and the LH side.



4. REMOVE NO.2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    B108512E02

  1. Using a screwdriver, push the 3 claws in the direction indicated by the arrow to disengage and remove the guide on the front of the vehicle.

    HINT:
    Tape the screwdriver tip before use.

  1. Disconnect the connectors and remove the instrument panel No.2 under cover sub-assembly.



5. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY


    B108513E02

  1. Remove the 2 bolts <A> and the 2 screws <C>.

  1. Pull the glove compartment door assembly to the rear to remove it.

  1. Disconnect the connector.



6. REMOVE NETWORK GATEWAY ECU


    E110443

  1. Disconnect the connector.

  1. Remove the screw and the network gateway ECU.