STEERING PAD SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent the airbag working. (Click here)



2. REMOVE NO.3 STEERING WHEEL COVER LOWER


    C111800

  1. Using a screwdriver, remove the steering wheel No.3 cover lower.

    HINT:
    Tape up the screwdriver tip before use.



3. REMOVE NO.2 STEERING WHEEL COVER LOWER


    C111801

  1. Using a screwdriver, remove the steering wheel No.2 cover lower.

    HINT:
    Tape up the screwdriver tip before use.



4. REMOVE STEERING PAD


    C111802E01

  1. Using a "torx" socket wrench (T30), loosen the 2 "torx" screws until the groove along the screw circumference catches on the screw case.



    C111064

  1. Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand as shown in the illustration.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.

  1. Disconnect the horn connector.

  1. Disconnect the 2 connectors from the steering pad.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Remove the steering pad.



5. REMOVE STEERING PAD SWITCH LH


    E111385E01

  1. Disconnect the connector.

  1. Remove the screw.

  1. Disengage the 2 claws and the pin.

  1. Remove the steering pad switch LH.



6. REMOVE STEERING PAD SWITCH RH


    E111386E01

  1. Disconnect the connector.

  1. Remove the screw.

  1. Disengage the 2 claws and the pin.

  1. Remove the steering pad switch RH.