PARKING ASSIST MONITOR SYSTEM > PRECAUTION

for Preparation Click here



NOTICE:
When disconnecting the negative (-) battery terminal, initialize the following system(s) after the terminal is reconnected.

System Name
See procedure
Lighting System
 Click here
Sliding Roof System
Power Window Control System
Power Door Lock Control System
Power Back Door System
Back Door Closer System
Electrical Back Door Outside Handle System
SFI System


1.POINTS TO NOTE WHEN SERVICING

  1. The maximum steering angle setting must be carried out with the engine on. Apply the parking brake, depress the brake pedal, move the shift lever to the N position, and ensure that the vehicle is not running.

  2. Pay attention to the following points when servicing:

    1. When disconnecting the battery cable, "SYSTEM INITIALIZING" appears on the screen. In this case, correct the steering angle neutral point (Click here).

    2. When replacing the television camera ECU, "SYSTEM NOT READY" appears on the screen. In this case, set the maximum steering angle and steering angle neutral point, and adjust the line display position. In addition, when the television camera assembly is replaced or displaced, readjustment of the line display position is required (Click here).