PARKING ASSIST MONITOR SYSTEM
Symptom
| Suspected area
| See page
|
When shift lever is in R position, rear view monitor image is not displayed (Screen is not black).
| 1. Power source circuit
|
Click here
|
2. Reverse signal (CAN communication system) (for LHD)
|
Click here
|
3. Reverse signal (CAN communication system) (for RHD)
|
Click here
|
4. Replace television camera ECU
|
Click here
|
When shift lever is in R position, rear view monitor image is not displayed (Screen is black).
| 1. Display signal circuit between television camera assembly and television camera ECU
|
Click here
|
2. Replace television camera assembly
|
Click here
|
3. Replace television camera ECU
|
Click here
|
When shift lever is not in R position, rear view monitor image is displayed.
| 1. Reverse signal (CAN communication system) (for LHD)
|
Click here
|
2. Reverse signal (CAN communication system) (for RHD)
|
Click here
|
3. Replace television camera ECU
|
Click here
|
Even if switching into "Parallel Parking Assist" mode, system changes into "Manual" mode.
| 1. Steering angle sensor signal (CAN communication system) (for LHD)
|
Click here
|
2. Steering angle sensor signal (CAN communication system) (for RHD)
|
Click here
|
3. Replace navigation ECU
|
Click here
|
4. Replace television camera ECU
|
Click here
|
Problem with the rear view monitor image (color, disorder of picture).
| 1. Display signal circuit between television camera assembly and television camera ECU
|
Click here
|
2. Display signal circuit between television camera ECU and navigation ECU
|
Click here
|
3. Replace television camera assembly
|
Click here
|
4. Replace television camera ECU
|
Click here
|
5. Replace navigation ECU
|
Click here
|
When parking the vehicle with "Parallel Parking Assist" mode, even if vehicle starts to run, screen does not change.
| 1. This may occur when reversing at very low speed.
|
Click here
|
"SYSTEM INITIALIZING" is displayed.
| 1. Correct the steering angle neutral point without fail.
|
Click here
|
