POWER WINDOW REGULATOR MOTOR > INSPECTION

for Preparation Click here



1. INSPECT POWER WINDOW REGULATOR MOTOR (FRONT RH)


    B067305E01

  1. Remove the power window regulator motor.

  1. Apply battery voltage to the motor connector according to the table below.

    NOTICE:
    Do not apply battery to any terminals except terminals 1 and 2.

    Standard:
    Measurement Condition
    		Specified Condition
    Battery positive (+) → Terminal 1 (D)
    Battery negative (-) → Terminal 2 (U)
    		Motor gear rotates clockwise
    Battery positive (+) → Terminal 2 (U)
    Battery negative (-) → Terminal 1 (D)
    		Motor gear rotates counterclockwise



2. INSPECT POWER WINDOW REGULATOR MOTOR (FRONT LH)


    B067306E01

  1. Remove the power window regulator motor.

  1. Apply battery voltage to the motor connector according to the table below.

    NOTICE:
    Do not apply battery to any terminals except terminals 1 and 2.

    Standard:
    Measurement Condition
    		Specified Condition
    Battery positive (+) → Terminal 1 (D)
    Battery negative (-) → Terminal 2 (U)
    		Motor gear rotates counterclockwise
    Battery positive (+) → Terminal 2 (U)
    Battery negative (-) → Terminal 1 (D)
    		Motor gear rotates clockwise



3. INSPECT POWER WINDOW REGULATOR NOTOR (REAR RH)


    B067305E01

  1. Remove the power window regulator motor.

  1. Apply battery voltage to the motor connector according to the table below.

    NOTICE:
    Do not apply battery to any terminals except terminals 1 and 2.

    Standard:
    Measurement Condition
    		Specified Condition
    Battery positive (+) → Terminal 1 (D)
    Battery negative (-) → Terminal 2 (U)
    		Motor gear rotates clockwise
    Battery positive (+) → Terminal 2 (U)
    Battery negative (-) → Terminal 1 (D)
    		Motor gear rotates counterclockwise



4. INSPECT POWER WINDOW REGULATOR MOTOR (REAR LH)


    B067306E01

  1. Remove the power window regulator motor.

  1. Apply battery voltage to the motor connector according to the table below.

    NOTICE:
    Do not apply battery to any terminals except terminals 1 and 2.

    Standard:
    Measurement Condition
    		Specified Condition
    Battery positive (+) → Terminal 1 (D)
    Battery negative (-) → Terminal 2 (U)
    		Motor gear rotates counterclockwise
    Battery positive (+) → Terminal 2 (U)
    Battery negative (-) → Terminal 1 (D)
    		Motor gear rotates clockwise