TURN SIGNAL LIGHT SWITCH > ON-VEHICLE INSPECTION

for Preparation Click here

1. Disconnect the turn signal flasher connector.
   

2. Measure the voltage according to the value(s) in the table below.
   

   Voltage:

   Tester connection	Condition	Specified condition
   1 - Body ground	Ignition switch OFF	Below 1 V
   1 - Body ground	Ignition switch ON	10 to 14 V
   4 - Body ground	Always	10 to 14 V
   7 - Body ground	Always	Below 1 V

3. Reconnect the turn signal flasher connector.
   

4. Measure the voltage according to the value(s) in the table below.
   

   Voltage:

   Tester connection	Condition	Specified condition
   2 - Body ground	Hazard warning switch OFF	Below 1 V
   2 - Body ground	Hazard warning switch ON	10 to 14 V (60 to 120 times per minute)
   2 - Body ground	Ignition switch ON and turn signal switch (right turn) OFF	Below 1 V
   2 - Body ground	Ignition switch ON and turn signal switch (right turn) ON	10 to 14 V (60 to 120 times per minute) Below 1 V
   3 - Body ground	Hazard warning switch OFF	Below 1 V
   3 - Body ground	Hazard warning switch ON	10 to 14 V (60 to 120 times per minute)
   3 - Body ground	Ignition switch ON and turn signal switch (left turn) OFF	Below 1 V
   3 - Body ground	Ignition switch ON and turn signal switch (left turn) ON	10 to 14 V (60 to 120 times per minute) Below 1 V
   5 - Body ground	Ignition switch ON and turn signal switch (left turn) OFF	10 to 14 V
   5 - Body ground	Ignition switch ON and turn signal switch (left turn) ON	Below 1 V
   6 - Body ground	Ignition switch ON and turn signal switch (right turn) OFF	10 to 14 V
   6 - Body ground	Ignition switch ON and turn signal switch (right turn) ON	Below 1 V
   8 - Body ground	Hazard warning switch OFF	10 to 14 V
   8 - Body ground	Hazard warning switch ON	Below 1 V

   If the result is not as specified, replace the turn signal flasher.