HAZARD WARNING SWITCH > INSPECTION

for Preparation Click here



1. INSPECT HAZARD WARNING SWITCH (W/O LEXUS NAVIGATION SYSTEM)


    E069433

  1. Remove the center cluster integration switch assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester Connection
    		Switch condition
    		Specified condition
    7 - 11
    		OFF
    		10 kΩ or higher
    7 - 11
    		ON
    		Below 1Ω

    If the result is not as specified, replace the center cluster integration switch assembly (hazard warning switch).



2. INSPECT HAZARD WARNING SWITCH (W/ LEXUS NAVIGATION SYSTEM)


    E068611E02

  1. Remove the multi-display assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester Connection
    		Switch condition
    		Specified condition
    M1-12 - M3-6
    		OFF
    		10 kΩ or higher
    M1-12 - M3-6
    		ON
    		Below 1Ω

    If the result is not as specified, replace the multi-display assembly (hazard warning switch).