STOP LIGHT SWITCH > INSPECTION

for Preparation Click here



1. INSPECT STOP LIGHT SWITCH


    E065594E05

  1. Remove the stop light switch.

  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester Connection
    		Switch position
    		Specified condition
    1 - 2
    		Switch pin free
    		10 kΩ or higher
    3 - 4
    		Switch pin free
    		Below 1 Ω
    1 - 2
    		Switch pin pushed in
    		Below 1 Ω
    3 - 4
    		Switch pin pushed in
    		10 kΩ or higher

    If the result is not as specified, replace the stop light switch.