REAR COMBINATION LIGHT ASSEMBLY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT REAR COMBINATION LIGHT ASSEMBLY


    E069342

  1. Measure the voltage according to the value(s) in the table below.

    Voltage:
    Tester connection
    		Condition
    		Specified condition
    1 - 2
    		Brake pedal released
    		Below 1 V
    1 - 2
    		Brake pedal depressed
    		10 to 14 V

  1. Disconnect the rear combination light assembly connector.

  1. Measure the resistance of the rear combination light according to the value(s) in the table below.

    Resistance:
    Tester connection
    		Condition
    		Specified condition
    1 - 2
    		Always
    		317 to 347 Ω

    If the result is not as specified, replace the light.