HEADLIGHT DIMMER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT HEADLIGHT DIMMER SWITCH


    E068152

  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Light control switch:
    Tester connection
    		Switch condition
    		Specified condition
    12 - 18
    		OFF
    		10 kΩ or higher
    18 - 19
    		OFF
    		10 kΩ or higher
    19 -20
    		OFF
    		10 kΩ or higher
    12 - 18
    		TAIL
    		Below 1 Ω
    12 - 18
    		HEAD
    		Below 1 Ω
    18 - 20
    		HEAD
    		Below 1 Ω
    12 - 19
    		AUTO
    		Below 1 Ω
    Headlight dimmer switch:
    Tester connection
    		Switch condition
    		Specified condition
    12 - 17
    		FLASH
    		Below 1 Ω
    12 - 16
    		LOW BEAM
    		Below 1 Ω
    11 - 12
    		HI BEAM
    		Below 1 Ω
    Turn signal switch:
    Tester connection
    		Switch condition
    		Specified condition
    12 - 13
    		Right turn
    		Below 1 Ω
    12 - 13
    		Neutral
    		10 kΩ or higher
    13 - 15
    		Neutral
    		10 kΩ or higher
    12 - 15
    		Left turn
    		Below 1 Ω
    Fog light switch:
    Tester connection
    		Switch condition
    		Specified condition
    3 - 4
    		OFF
    		10 kΩ or higher
    3 - 2
    		OFF
    		10 kΩ or higher
    2 - 4
    		OFF
    		10 kΩ or higher
    3 - 4
    		Front fog light switch ON
    		Below 1 Ω
    3 - 2
    		Rear fog light switch ON
    		Below 1 Ω
    2 - 4
    		Rear fog light switch ON
    		Below 1 Ω

    If the result is not as specified, replace the headlight dimmer switch.