AIRBAG SYSTEM > Diagnosis Circuit

for Preparation Click here


DESCRIPTION

DTC output mode is set by connecting terminals TC and CG of the DLC3.
DTCs are displayed by blinking the SRS warning light.

HINT:
  1. Make sure that DTC B1281 has not been output. If DTC B1281 has been output, refer to the multiplex communication system.
  2. When each warning light stays blinking, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in each ECU is suspected.
  3. A DTC output mode signal is transmitted through BEAN to each ECU including the center airbag sensor assembly, except for the skid control ECU with actuator. Thus when all systems except the ABS system do not enter DTC output mode, it can be suspected that there is an ECM malfunction.


WIRING DIAGRAM


C116300E01


C111749E02


INSPECTION PROCEDURE

1.CHECK WIRE HARNESS (DLC3 - ECM)


    C111739E01

  1. Turn the ignition switch to the LOCK position.

  1. Disconnect the center airbag sensor assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester connection
    		Condition
    		Specified condition
    D1-13 (TC) -
    H29-3 (TC)
    		Always
    		Below 1 Ω



NG
REPAIR OR REPLACE WIRE HARNESS (TC OF DLC3 - TC OF HYBRID VEHICLE CONTROL ECU)
OK


2.CHECK WIRE HARNESS (CG OF DLC3 - BODY GROUND)


    H040173E19

  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester connection
    		Condition
    		Specified condition
    D1-4 (CG) -
    Body ground
    		Always
    		Below 1 Ω



NG
REPAIR OR REPLACE WIRE HARNESS (CG OF DLC3 - BODY GROUND)
OK


3.CHECK WIRE HARNESS (TC OF HYBRID VEHICLE CONTROL ECU - BODY GROUND)


    E110177E04

  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester connection
    		Condition
    		Specified condition
    H29-3 (TC) -
    Body ground
    		Always
    		1 MΩ or higher



NG
REPAIR OR REPLACE WIRE HARNESS OR EACH ECU
OK


4.REPLACE ECM

  1. Check that the ECM.

    Result:
    A:
    Normal system code is output.
    B:
    DTC is output.
    C:
    ECM does not set the DTC output mode.



A
END

B
GO TO INSPECTION PROCEDURE OF DTC OUTPUT
C

REPLACE CENTER AIRBAG SENSOR ASSEMBLY