HYBRID TRANSAXLE SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT OIL PRESSURE IN OIL PUMP

NOTICE:
Do the test at normal operating oil temperature 50 to 80°C (122 to 176°F).

  1. Lift up the vehicle.



    C103082E01

  1. Remove the fluid pump cover plug and install SST.

    SST
    09992-00095   (09992-00112, 09992-00271)



    E109221E03

  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to the ON position.

  1. Select the inspection mode. (Click here)

  1. On the tester, enter the following menus: Powertrain / Hybrid Control / Active Test / Inspection Mod 1.

  1. Turn the ignition switch to the ON position with the brake pedal depressed to start the engine (start the hybrid system).

  1. Measure the oil pressure.

    Oil pressure:
    9.8 kPa (0.1 kgf/cm2, 1.4 psi) or more

    NOTICE:
    Be sure to cancel the inspection mode immediately after the oil pressure check is completed. (Click here)



    C103083

  1. Install a new O-ring and fluid pump cover plug.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }