NAVIGATION SYSTEM > Display Signal Circuit between Television Camera ECU and Multi-display

for Preparation Click here


DESCRIPTION

This is the display signal circuit from the television camera ECU to the multi-display.

WIRING DIAGRAM


E111745E02


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (TELEVISION CAMERA ECU - MULTI-DISPLAY)


    E111820E03

  1. Disconnect the television camera ECU connector T15 and multi-display connector M4.

  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester connection
    		Condition
    		Specified condition
    R - R
    		Always
    		Below 1 Ω
    G - G
    		Always
    		Below 1 Ω
    B - B
    		Always
    		Below 1 Ω
    SYNC - SYNC
    		Always
    		Below 1 Ω
    VR - VR
    		Always
    		Below 1 Ω
    R - Body ground
    		Always
    		10 kΩ or higher
    G - Body ground
    		Always
    		10 kΩ or higher
    B - Body ground
    		Always
    		10 kΩ or higher
    SYNC - Body ground
    		Always
    		10 kΩ or higher
    VR - Body ground
    		Always
    		10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT TELEVISION CAMERA ECU (OUTPUT SIGNAL)


    E111742E01

  1. Reconnect the television camera ECU connector T15.

  1. Measure the waveform according to the table below.

    OK:
    Tester connection
    		Condition
    		Specified condition
    R - Body ground
    		Navigation map is switched
    		A waveform synchronized with display signals is output
    G - Body ground
    		Navigation map is switched
    		A waveform synchronized with display signals is output
    B - Body ground
    		Navigation map is switched
    		A waveform synchronized with display signals is output
    SYNC - Body ground
    		Navigation display is ON
    		A waveform synchronized with display signals is output

    HINT:
    The waveform pattern may differ from those shown in the illustrations below due to differences in oscilloscope setting. A normal television camera ECU operating condition can be determined if any waveform is output.



    E111832E01

  1. Oscilloscope wave

    1. Terminal: SYNC - Body ground
      Setting: 500 mV/DIV 10 μs/DIV
      Condition: Navigation display is ON.

    2. Terminal: R, G, B - Body ground
      Setting: 200 mV/DIV 10 μs/DIV
      Condition: Navigation map is switched.



NG
REPLACE TELEVISION CAMERA ECU
OK

RETURN TO THE ORIGINAL INSPECTION FLOW BECAUSE THE CHECK RESULT IS NORMAL