ELECTRICAL BACK DOOR OUTSIDE HANDLE SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



READ DATA LIST

HINT:
Using the intelligent tester's DATA LIST allows switch, actuator and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to save time.

  1. Connect the intelligent tester with CAN VIM to the DLC3.

  2. Turn the ignition switch to the ON position.

  3. Read the DATA LIST.

    Body ECU 
    Item
    		Measurement Item /
    Display (Range)
    		Normal Condition
    		Diagnostic Note
    Back Door Open SW
    		Back door opener switch signal (Outside handle switch)
    /ON or OFF
    		ON: Back door opener switch is pushed
    OFF: Back door opener switch is not pushed
    		-

    Power back door ECU 
    Item
    		Measurement Item /
    Display (Range)
    		Normal Condition
    		Diagnostic Note
    Back Door Handle SW
    		Back door opener switch signal (Outside handle switch)
    /ON or OFF
    		ON: Back door opener switch is pushed
    OFF: Back door opener switch is not pushed
    		-


PERFORM ACTIVE TEST

HINT:
Performing the intelligent tester's ACTIVE TEST allows relay, VSV, actuator, and other items to be operated without removing any parts. Performing the ACTIVE TEST early in troubleshooting is one way to save time. The DATA LIST can be displayed during the ACTIVE TEST.

  1. Connect the intelligent tester with CAN VIM to the DLC3.

  2. Turn the ignition switch to the ON position.

  3. Perform the ACTIVE TEST.

    Body ECU 
    Item
    		Test Details
    		Diagnostic Note
    Trunk and Back-Door Open
    		Operate back door open
    OFF/ON
    		-

    Power back door ECU 
    Item
    		Test Details
    		Diagnostic Note
    Latch Release
    		Back door lock latch is released
    OFF/ON
    		-