FRONT PASSENGER SEAT BELT WARNING LIGHT > INSPECTION

for Preparation Click here



1. INSPECT INTEGRATION CONTROL & PANEL (W/O NAVIGATION SYSTEM)


    B115739E01

  1. Disconnect the C4 connector.

  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    		Condition
    		Specified Condition
    C4-9 (IG) - Body ground
    		Ignition switch ON
    		10 to 14 V

    Standard resistance:
    Tester Connection
    		Condition
    		Specified Condition
    C4-7 (GND) - Body ground
    		Always
    		Below 1 Ω



2. INSPECT MULTI-DISPLAY (W/ NAVIGATION SYSTEM)


    B111225E03

  1. Disconnect the M1 connector.

  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    		Condition
    		Specified Condition
    M1-10 (IG+) - Body ground
    		Ignition switch ON
    		10 to 14 V
    M1-21 (PBEW) - Body ground
    		Ignition switch ON, sit on the front passenger seat, seat belt is unfastened → Fastened
    		10 to 14 V → Below 1 V

    Standard resistance:
    Tester Connection
    		Condition
    		Specified Condition
    M1-3 (GND) - Body ground
    		Always
    		Below 1 Ω