STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic) > INSPECTION

for Preparation Click here



1. INSPECT STEERING LOCK OPERATION


    C111456E01

  1. Check that the steering lock mechanism is activated when the key is removed.



    C111457

  1. Check that the steering lock mechanism is deactivated when the key is inserted and turned to the ACC position.

    HINT:
    If there is any abnormality, replace the ignition switch lock cylinder assembly.



2. INSPECT TILT MOTOR


    C106479E01

  1. Connect the positive battery terminal to terminal TIM+ and the negative battery terminal to terminal TIM- of the tilt motor connector. Then confirm that the steering wheel tilts up.

    OK:
    Steering wheel tilts up.

  1. Connect the negative battery terminal to terminal TIM+ and the positive battery terminal to terminal TIM- of the tilt motor connector. Then confirm that the steering wheel tilts down.

    OK:
    Steering wheel tilts down.



3. INSPECT TELESCOPIC MOTOR


    C115826E01

  1. Connect the positive battery terminal to terminal TEM+ and the negative battery terminal to terminal TEM- of the telescopic motor connector. Then confirm that the steering column contracts.

    OK:
    Steering column contracts.

  1. Connect the negative battery terminal to terminal TEM+ and the positive battery terminal to terminal TEM- of the telescopic motor connector. Then confirm that the steering column extends.

    OK:
    Steering column extends.