MULTIPLEX TILT AND TELESCOPIC ECU > INSTALLATION

for Preparation Click here



1. INSTALL MULTIPLEX TILT AND TELESCOPIC ECU


    C111451

  1. Using a socket wrench (+), install the multiplex tilt and telescopic ECU with the 2 screws.

    Torque:
    1.5 N*m{ 15 kgf*cm , 13 in.*lbf }

  1. Connect the connectors to the multiplex tilt and telescopic ECU.

    NOTICE:
    1. The connectors on both ends of the wire harness between the telescopic motor and ECU are the same shape.
    2. When installing them, connect the connectors of the same color.



2. INSTALL STEERING COLUMN UPPER WITH SWITCH BRACKET ASSEMBLY

  1. Temporarily install the steering column upper with switch bracket assembly with 2 new tapered-head bolts.



    C111455

  1. Tighten the 2 tapered-head bolts until the bolt heads break off.



3. INSTALL STEERING COLUMN ASSEMBLY

HINT:
Refer to the instructions for installation of the steering column assembly (power tilt and power telescopic) (Click here).