FRONT STEREO COMPONENT SPEAKER > REMOVAL

for Preparation Click here



1. REMOVE FRONT PILLAR GARNISH


    B111784E01

  1. Detach clip (A) from the vehicle body. Pull the pillar garnish so that the tip of clip (B) locks in the pillar garnish hole.

  1. Using needle-nose pliers, rotate clip (B) 90°.

  1. Disengage the 2 claws and remove the front pillar garnish.

  1. Remove clip (B).



    B111785E01

  1. Protect the curtain shield airbag assembly.

    1. Thoroughly cover the airbag with a cloth or nylon sheet that is 700 mm (27.56 in.) x 120 mm (4.72 in.) and fix the ends of the cover with adhesive tape, as shown in the illustration.

      NOTICE:
      Cover the curtain shield airbag with a protective cover as soon as the front pillar garnish is removed.



2. REMOVE FRONT STEREO COMPONENT SPEAKER


    E111380

  1. Disconnect the connector.

  1. Remove the bolt and disengage the claw.

  1. Remove the front stereo component speaker.