ELECTRICAL BACK DOOR OUTSIDE HANDLE SYSTEM > Back Door Opener Switch Circuit

for Preparation Click here


DESCRIPTION

The back door opener switch only turns on while the back door handle is being pulled, and turns off when the handle is released.
The body ECU is connected to the back door opener switch via terminal BDSU and back door unlatch operation request signals are input to the ECU.
The body ECU applies voltage to the back door opener switch via terminal BDSU. When the switch is on (there is continuity between the switch terminals), a back door unlatch operation request signal is input to the body ECU.
w/o Power back door system:
The body ECU directly activates the motor built into the back door lock assembly to unlatch the back door.
w/ Power back door system:
The body ECU, using multiplex communication, sends signals input from the back door operation switch to the power back door ECU. The power back door ECU then activates the motor built into the back door lock assembly to unlatch the back door based on the signals.

WIRING DIAGRAM


B109773E22


INSPECTION PROCEDURE

1.READ VALUE OF DATA LIST (BACK DOOR OPENER SWITCH)

  1. Check the DATA LIST to ensure proper function of the power back door opener switch.

    Body ECU: 
    Item
    		Measurement Item /
    Display (Range)
    		Normal Condition
    		Diagnostic Note
    Back Door Open SW
    		Back door opener switch signal (Outside handle switch)
    /ON or OFF
    		ON: Back door opener switch is pushed
    OFF: Back door opener switch is not pushed
    		-

    OK:
    The display is as specified in the normal condition.



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE 

2.INSPECT BACK DOOR OPENER SWITCH ASSEMBLY


    B068466E01

  1. Remove the back door opener switch assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    		Switch Position
    		Specified Condition
    1 - 2
    		Free
    		10 kΩ or higher
    1 - 2
    		Pushed
    		Below 1 Ω



NG
REPLACE BACK DOOR OPENER SWITCH ASSEMBLY
OK


3.CHECK WIRE HARNESS (BACK DOOR OPENER SWITCH - INSTRUMENT PANEL J/B (BODY ECU))


    B111704E02

  1. Disconnect the back door opener switch assembly connector.

  1. Disconnect the instrument panel J/B connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    		Condition
    		Specified Condition
    P10-2 - B7-3 (BDSU)
    		Always
    		Below 1 Ω
    P10-1 - Body ground
    		Always
    		Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE