FUEL LID OPENER SYSTEM > INSPECTION

for Preparation Click here



1. INSPECT FUEL LID W/MOTOR LOCK ASSEMBLY


B069149E01

  1. Apply battery voltage to the lock control and check the motor operates in the direction.

    Standard:
    Measurement Condition
    		Specified Condition
    Battery positive (+) → Terminal 2
    Battery negative (-) → Terminal 1
    		Open direction

  1. Check the shaft stroke.

    Standard:
    10.3 mm (0.406 in.) or more



2. INSPECT FUEL FILLER DOOR OPENER SWITCH


B069150E01

  1. Check the fuel filler door opener switch resistance.

    Tester Connection
    		Switch Position
    		Specified Condition
    3 - 4
    		OFF (Release)
    		10 kΩ or higher
    3 - 4
    		ON (Pushed in)
    		Below 1 Ω

    If the result is not as specified, replace the fuel filler door opener switch.