FRONT NO. 1 SPEAKER > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT FRONT NO.1 SPEAKER

HINT:
Remove interior parts so that the front No.1 speaker can be seen.

  1. Check the speaker installation.

    OK:
    The speaker is securely installed.

    If the result is not as specified, reinstall the front No.1 speaker.

  1. Visually check the speaker.

    OK:
    The cone paper of the speaker is not torn.

    If the result is not as specified, replace the front No.1 speaker.

  1. Speaker resistance check

    1. Disconnect the front No.1 speaker connector.

    2. Measure the resistance between the terminals of the speaker.

      Standard resistance:
      Standard system:
      Approximately 2 Ω
      Mark Levinson system:
      7 to 9 Ω

      If the result is not as specified, replace the front No.1 speaker.