STEERING PAD SWITCH > INSPECTION

for Preparation Click here



1. INSPECT STEERING PAD SWITCH LH


  1. Measure the resistance according to the values in the table below.


    I035645E02


    Standard resistance:

    Tester connection
    		Condition
    		Specified condition
    AU1 - EAU
    		No switch is pushed
    		Approx. 100 kΩ
    AU1 - EAU
    		SEEK+ switch: push
    		Approx. 0 Ω
    AU1 - EAU
    		SEEK- switch: push
    		Approx. 0.3 kΩ
    AU1 - EAU
    		VOL+ switch: push
    		Approx. 1 kΩ
    AU1 - EAU
    		VOL- switch: push
    		Approx. 3.2 kΩ
    AU2 - EAU
    		No switch is pushed
    		Approx. 100 kΩ
    AU2 - EAU
    		MODE switch: push
    		Approx. 0 Ω

    If the result is not as specified, replace the steering pad switch LH.



2. INSPECT STEERING PAD SWITCH CABLE SUB-ASSEMBLY


  1. Measure the resistance according to the values in the table below.


    I046006E01


    Standard resistance:

    Tester connection
    		Condition
    		Specified condition
    A-1 - B-1
    		Always
    		Below 1 Ω
    A-2 - B-2
    		Always
    		Below 1 Ω
    A-3 - B-3
    		Always
    		Below 1 Ω
    A-4 - B-4
    		Always
    		Below 1 Ω
    A-5 - B-5
    		Always
    		Below 1 Ω
    A-6 - B-6
    		Always
    		Below 1 Ω
    A-7 - B-7
    		Always
    		Below 1 Ω
    A-8 - B-8
    		Always
    		Below 1 Ω

    If the result is not as specified, replace the steering pad switch cable sub-assembly.



3. INSPECT STEERING PAD SWITCH RH


  1. Measure the resistance according to the values in the table below.


    I045245E02


    Standard resistance:

    Tester connection
    		Condition
    		Specified condition
    AU2 - EAU
    		No switch is pushed
    		Approx. 100 kΩ
    AU2 - EAU
    		VOICE switch: push
    		Approx. 3.2 kΩ
    AU2 - EAU
    		ON HOOK switch: push
    		Approx. 0.3 kΩ
    AU2 - EAU
    		OFF HOOK switch: push
    		Approx. 1.0 kΩ

    If the result is not as specified, replace the steering pad switch RH.