LIGHTING SYSTEM > Overhead Console Illumination Light Circuit

for Preparation Click here


DESCRIPTION

The body ECU controls the overhead console illumination light.

WIRING DIAGRAM


B110603E02


INSPECTION PROCEDURE

1.PERFORM ACTIVE TEST BY INTELLIGENT TESTER

  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to the ON position and press the intelligent tester main switch ON.

  1. Select the items below in the ACTIVE TEST, and then check that the light comes on.

    BODY NO.1 
    Item
    		Test Details
    		Diagnostic Note
    Center Console Light Operation
    		Center console light ON/OFF
    		-



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE 

2.INSPECT PERSONAL LIGHT ASSEMBLY


    E068610E01

  1. Disconnect the overhead junction block connector.

  1. Connect the positive (+) lead from the battery to the terminal 13 and negative (-) lead from the battery to the terminal 4.

  1. Inspect the overhead console illumination light comes on.



NG
REPLACE PERSONAL LIGHT ASSEMBLY
OK


3.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY


  1. Measure the voltage according to the value(s) in the table below.


    E068632E15

    Voltage:
    Tester connection
    		Condition
    		Specified condition
    B7-14 - Body ground
    		All door is closed → Front or rear door is open
    		10 to 14 V → Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE