OIL COOLER ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE ENGINE UNDER COVER NO.1


    A108722

  1. Remove the 6 bolts, 2 screws, 2 clips and engine under cover.



2. DRAIN HYBRID TRANSAXLE FLUID


    C105763E01

  1. Using a socket hexagon wrench 10 mm, remove the filler plug and gasket.

  1. Using a socket hexagon wrench 10 mm, remove the drain plug and gasket.

  1. Using a socket hexagon wrench 10 mm, install the drain plug, and a new gasket.

    Torque:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }



3. REMOVE FRONT BUMPER ASSEMBLY
(Click here)


4. REMOVE OIL NO.1 COOLER ASSEMBLY

  1. Disconnect the 2 oil cooler hoses.



    C113112

  1. Remove the 3 bolts, and oil cooler assembly.



    C113874

  1. Remove the 3 bolts and air duct.