POWER WINDOW CONTROL SYSTEM > OPERATION CHECK

for Preparation Click here



CHECK WINDOW LOCK SWITCH
B066761

  1. Check that the front passenger side power window and rear power window operation is disabled when the window lock switch of the power window master switch is pressed.

    standard:
    Front passenger side power window and rear power window operation is disabled.

  2. Check that the front passenger side power window and rear power windows can be operated when the window lock switch is pressed again.

    standard:
    Front passenger side power window and rear power windows can be operated.


CHECK MANUAL UP/DOWN FUNCTION

  1. Check that the driver side power window operates as follows:

    Standard:

    Condition
    		Master Switch
    		Switch Operation
    		Power Window
    Ignition switch ON
    		Driver side
    		Pulled halfway up
    		UP (Closed)
    Pushed halfway down
    		DOWN (Open)

  2. Check that the power windows except the driver side power window operates as follows:

    Standard:

    Condition
    		Master Switch
    		Switch Operation
    		Power Window
    1. Ignition switch ON
    2. Window lock switch OFF
    		Passenger side
    		Pulled halfway up
    		UP (Closed)
    Pushed halfway down
    		DOWN (Open)
    Rear LH
    		Pulled halfway up
    		UP (Closed)
    Pushed halfway down
    		DOWN (Open)
    Rear RH
    		Pulled halfway up
    		UP (Closed)
    Pushed halfway down
    		DOWN (Open)


CHECK AUTO UP/DOWN FUNCTION

  1. Check that the driver side power window operates as follows:

    Standard:

    Condition
    		Master Switch
    		Switch Operation
    		Power Window
    Ignition switch ON
    		Driver side
    		Pulled halfway up
    		UP (Closed)
    Pushed halfway down
    		DOWN (Open)

  2. Check that the power windows except the driver side power window operate as follows:

    Standard:

    Condition
    		Master Switch
    		Switch Operation
    		Power Window
    1. Ignition switch ON
    2. Window lock switch OFF
    		Passenger side
    		Pulled halfway up
    		UP (Closed)
    Pushed halfway down
    		DOWN (Open)
    Rear LH
    		Pulled halfway up
    		UP (Closed)
    Pushed halfway down
    		DOWN (Open)
    Rear RH
    		Pulled halfway up
    		UP (Closed)
    Pushed halfway down
    		DOWN (Open)


CHECK REMOTE MANUAL UP/DOWN FUNCTION

  1. Check that the power windows except the driver side power window operate as follows:

    Standard:

    Condition
    		Master Switch
    		Switch Operation
    		Power Window
    1. Ignition switch ON
    2. Window lock switch OFF
    		Passenger side
    		Pulled halfway up
    		UP (Closed)
    Pushed halfway down
    		DOWN (Open)
    Rear LH
    		Pulled halfway up
    		UP (Closed)
    Pushed halfway down
    		DOWN (Open)
    Rear RH
    		Pulled halfway up
    		UP (Closed)
    Pushed halfway down
    		DOWN (Open)


CHECK REMOTE AUTO UP/DOWN FUNCTION

  1. Check that the power windows except the driver side power window operate as follows:

    Standard:

    Condition
    		Master Switch
    		Switch Operation
    		Power Window
    1. Ignition switch ON
    2. Window lock switch OFF
    		Passenger side
    		Pulled halfway up
    		UP (Closed)
    Pushed halfway down
    		DOWN (Open)
    Rear LH
    		Pulled halfway up
    		UP (Closed)
    Pushed halfway down
    		DOWN (Open)
    Rear RH
    		Pulled halfway up
    		UP (Closed)
    Pushed halfway down
    		DOWN (Open)


MANUAL UP/DOWN FUNCTION USING DRIVER SIDE DOOR LOCK KEY CYLINDER

  1. Check that all power windows and sliding roof (standard type only) operate as follows, when the key is inserted into the driver side door lock key cylinder:

    Standard:

    Condition
    		Key Operation
    		Position/Operation
    No key in ignition key cylinder
    		Turned left (LOCK) for more than 1.5 sec.
    		Driver and passenger side power windows/UP
    Turned left (LOCK) for more than 2.0 sec.
    		Rear LH and RH power windows/UP
    Turned left (LOCK) for more than 2.5 sec.
    		Sliding roof/CLOSE
    Turned right (UNLOCK) for more than 1.5 sec.
    		Driver and passenger side power windows/DOWN
    Turned right (UNLOCK) for more than 2.0 sec.
    		Rear LH and RH power windows/DOWN
    Turned right (UNLOCK) for more than 2.5 sec.
    		Sliding roof/OPEN


CHECK MANUAL DOWN FUNCTION USING TRANSMITTER

  1. Check that all power windows and sliding roof (standard type only) operate as follows when operating the transmitter:

    Standard:

    Condition
    		Transmitter Operation
    		Position/Operation
    1. No key in ignition key cylinder
    2. Any door unlocked
    		UNLOCK switch pressed for more than 1.5 sec.
    		Driver and passenger side power windows/DOWN
    UNLOCK switch pressed for more than 2.0 sec.
    		Rear LH and RH power windows/DOWN
    UNLOCK switch pressed for more than 2.5 sec.
    		Sliding roof/OPEN

    HINT:
    For a sign for starting operation, the wireless door lock buzzer sounds once (answer-back).


CHECK POWER WINDOW OPERATION FUNCTION AFTER IGNITION SWITCH IS TURNED OFF

  1. When both of the following conditions are fulfilled, check that the power windows can be operated even after the ignition switch is turned off.

    1. Within 45 seconds after the ignition switch is turned off.

    2. The front doors are closed.


CHECK JAM PROTECTION FUNCTION
B051853E01

HINT:
The jam protection function prevents any part of your body from getting caught by accident between the door frame and the door glass during power window operation.

NOTICE:
If the power window motor has been reset, raise and lower the door glass several times using MANUAL function before performing the check.

  1. Check that the door glass goes down by approx. 50 mm (1.97 in.) right when something gets caught between the door frame and door glass during power window operation. However, when the opening between the door frame and the door glass is less than 200 mm (7.87 in.), the door glass continues to go down and does not stop until an opening of 200 mm (7.87 in.) is achieved. Operative conditions:

    1. AUTO UP
    2. AUTO UP function after the ignition switch is turned off
    3. MANUAL UP function after the ignition switch is turned off
    4. MANUAL UP function using the driver side door lock key cylinder