HORN RELAY > INSPECTION

for Preparation Click here



1. INSPECT FUSE (HORN)

  1. Check the resistance of the HORN fuse.

    Standard:
    Below 1 Ω



2. INSPECT HORN RELAY


    B066959E01

  1. Remove the horn relay from the fusible link block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard:
    Tester Connection
    		Condition
    		Specified Condition
    3 - 5
    		Always
    		10 kΩ or higher
    3 - 5
    		When battery voltage is applied to terminals 1 and 2
    		Below 1 Ω