FRONT SPEED SENSOR > INSTALLATION

for Preparation Click here

1. Install the front speed sensor with the bolt.
   

   Torque:

   8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

   NOTICE:

   Prevent foreign matter from attaching to the sensor tip.

2. Install the front speed sensor with the 2 bolts and the clamp.
   

   Torque:

   Bolt A:

   5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

   Bolt B:

   19 N*m{ 194 kgf*cm , 14 ft.*lbf }

   NOTICE:

   Do not twist the wire harness for the front speed sensor when installing the front speed sensor.

3. Connect the front speed sensor connector.
   

1. Install the front fender splash shield sub-assembly with the bolts, screws, and clips.
   

Torque:

103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }