FRONT SPEED SENSOR > INSPECTION

for Preparation Click here



1. INSPECT FRONT SPEED SENSOR

  1. Inspect the front speed sensor. If any of the following occurs, replace the front speed sensor with a new one:

    1. The surface of the front speed sensor is cracked, dented, or chipped off.
    2. The connector is scratched, cracked, or damaged.
    3. The front speed sensor has been dropped.



    F100406E01

  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    LH 
    Tester Connection
    		Specified Condition
    2 (FL+) - 1 (FL-)
    		1.4 to 1.8 kΩ
    RH 
    Tester Connection
    		Specified Condition
    2 (FR+) - 1 (FR-)
    		1.4 to 1.8 kΩ

  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    LH 
    Tester Connection
    		Specified Condition
    1 (FL-) - Body ground
    		10 kΩ or higher
    2 (FL+) - Body ground
    		10 kΩ or higher
    RH 
    Tester Connection
    		Specified Condition
    1 (FR-) - Body ground
    		10 kΩ or higher
    2 (FR+) - Body ground
    		10 kΩ or higher