REAR SPEED SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL REAR SPEED SENSOR


    C108782

  1. Install the rear speed sensor with the bolt.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

    NOTICE:
    Prevent foreign matter from attaching to the sensor tip.



    C108781

  1. Install the sensor harness clamps with the 2 bolts to the body and the shock absorber bracket.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

    NOTICE:
    Do not twist the sensor wire when installing the sensor.

  1. Push in the sensor wire harness with the grommet.

    NOTICE:
    When installing the grommet, do not pull the sensor wire. Only pull the grommet.



    C108780

  1. Connect the rear speed sensor connector.



2. INSTALL REAR WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }



3. INSTALL REAR SEAT SIDE COVER


    B111791

  1. Engage the 4 clips and install the rear seat side cover.

  1. Install the 3 clips.



4. INSTALL DECK SIDE TRIM COVER


    B111808

  1. Engage the 5 claws and install the deck side trim cover.



5. INSTALL REAR DOOR OPENING TRIM WEATHER STRIP


6. INSTALL REAR DOOR SCUFF PLATE


    B111783

  1. Connect the connector. (w/ illumination scuff plate)

  1. Engage the 4 claws and 2 clips, and install the rear door scuff plate.



7. CHECK SPEED SENSOR SIGNAL
(Click here)