BRAKE CONTROL POWER SUPPLY > INSTALLATION

for Preparation Click here



1. INSTALL BRAKE CONTROL POWER SUPPLY


    C116222E01

  1. Install the 2 brackets with the 4 bolts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }



    C116221

  1. Install the brake control power supply with the 3 nuts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }



    C116220E01

  1. Connect the brake control power supply connector and install the clamp.



2. INSTALL DECK BOARD NO.1 CHECK

  1. Install the deck board No.1 check with the 4 nuts.



3. INSTALL DECK SIDE TRIM BOX RH


4. INSTALL DECK SIDE TRIM BOX LH


    B111781

  1. Install the deck side trim box with the 2 clips.



5. INSTALL REAR FLOOR FINISH PLATE


    B110477

  1. Engage the 2 claws and 6 clips, and install the rear floor finish plate.

  1. Install the 2 clips.



6. INSTALL DECK BOARD NO.2 SUB-ASSEMBLY


    B110024

  1. Install the deck No.2 board sub-assembly with the 4 bolts and 2 nuts.



7. INSTALL DECK BOARD NO.3 SUB-ASSEMBLY


    B110025

  1. Install the deck No.3 board sub-assembly with the 2 bolts and 2 nuts.



8. INSTALL DECK FLOOR BOX REAR


    B110023

  1. Install the deck floor box rear with the 2 clips.



9. INSTALL DECK FLOOR BOX FRONT


    B110022

  1. Install the deck floor box front with the 2 clips.



10. INSTALL DECK BOARD SUB-ASSEMBLY


    B110455

  1. Install the deck board sub-assembly with the 2 bolt.

  1. Engage the 5 clips.



11. CHECK AND CLEAR DTC
(Click here)


12. PERFORM INITIALIZATION
(Click here)
Some systems need initialization after reconnecting the cable to the negative battery terminal.