BRAKE CONTROL POWER SUPPLY > REMOVAL

for Preparation Click here



1. REMOVE DECK BOARD SUB-ASSEMBLY


    B110021

  1. Disengage the 5 clips and turn up the front side of the deck board.

  1. Remove the 2 bolts and deck board sub-assembly.



2. REMOVE DECK FLOOR BOX FRONT


    B110022

  1. Using a clip remover, remove the 2 clips and deck floor box front.



3. REMOVE DECK FLOOR BOX REAR


    B110023

  1. Using a clip remover, remove the 2 clips and deck floor box rear.



4. REMOVE DECK BOARD NO.2 SUB-ASSEMBLY


    B110024

  1. Remove the 4 blots, 2 nuts and deck No.2 board sub-assembly.



5. REMOVE DECK BOARD NO.3 SUB-ASSEMBLY


    B110025

  1. Remove the 2 bolts, 2 nuts and deck No.3 board sub-assembly.



6. REMOVE REAR FLOOR FINISH PLATE


    B111780

  1. Using a clip remover, remove the 2 clips.

  1. Disengage the 2 claws and 6 clips, and remove the rear floor finish plate.



7. REMOVE DECK SIDE TRIM BOX RH


8. REMOVE DECK SIDE TRIM BOX LH


    B111781E01

  1. Remove the clip (A).

  1. Using a clip remover, remove the clip (B) and deck side trim box.



9. REMOVE DECK BOARD NO.1 CHECK

  1. Remove the 4 nuts and deck board No.1 check.



10. REMOVE BRAKE CONTROL POWER SUPPLY


    C116220E01

  1. Disconnect the brake control power supply connector and separate the clamp.



    C116221

  1. Remove the 3 nuts and the brake control power supply.



    C116222E01

  1. Remove the 4 bolts and 2 brackets.