DTC    01-DD    Master Reset

DTC    01-E1    Voice Processing Device ON Error

for Preparation Click here


DESCRIPTION


DTC No.
DTC Detection Condition
Trouble Area
01-DD
*1
The device that should be the master has been disconnected after engine start
  1. Multi-display power source circuit
  1. AVC-LAN circuit between the multi-display and the component which has stored this code
  1. Multi-display
  1. Component which has stored this code
01-E1
*2
The AMP device records that the AMP output does not function even while the source device operates

HINT:
  1. *1: This code may be stored if the engine is started and the ignition switch is turned to the START position again.
  2. *2: Even if no failure is detected, a trouble code may be recorded depending on the battery condition or engine start voltage.

NOTICE:
  1. Be sure to clear and recheck DTCs and perform inspection according to the result to avoid the conditions shown in "HINT" above.
  2. The multi-display is the master unit.
  3. Be sure to clear and recheck DTCs after the inspection is completed to confirm that no DTCs are output.


INSPECTION PROCEDURE

NOTICE:
Be sure to read DESCRIPTION before performing the following procedures.

1.CHECK MULTI-DISPLAY POWER SOURCE CIRCUIT
Refer to the multi-display power source circuit (Click here).
If the power source circuit is operating normally, proceed to the next step.

NEXT


2.INSPECT RADIO RECEIVER


    E110926E01

  1. Disconnect the radio receiver connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester Connection
    		Condition
    		Specified Condition
    ATX+ (R2-5) -
    ATX- (R2-15)
    		Always
    		60 to 80 Ω
    TX+ (R3-9) -
    TX- (R3-10)
    		Always
    		60 to 80 Ω



NG
REPLACE RADIO RECEIVER
OK


3.IDENTIFY THE COMPONENT WHICH HAS STORED THIS CODE


    E111829E03

  1. Enter the diagnostic mode.

  1. Press the "LAN Mon" switch to change to "LAN Monitor" mode.

  1. Identify the component which has stored this code.

    Component Table 
    Display
    		Component
    AUDIO H/U
    		Radio Receiver
    DSP-AMP
    		Stereo Component Amplifier
    G/W
    		Gateway ECU
    NAVI
    		Navigation ECU
    CAMERA
    		Television Camera ECU

    HINT:
    "NAVI" is the component which has stored this code in the example shown in the illustration.


NEXT


4.CHECK HARNESS AND CONNECTOR (MULTI-DISPLAY - COMPONENT WHICH HAS STORED THIS CODE)

HINT:
For details of the connectors, refer to the "Terminals of ECU" (Click here).



  1. Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the multi-display and the component which has stored this code.



    1. Check for an open or short in the AVC-LAN circuit between the multi-display and the component which has stored this code.

      OK:
      There is no open or short circuit.


      E111828E02



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.REPLACE MULTI-DISPLAY

  1. Replace the multi-display with a normal one and check if the same problem occurs again.

    OK:
    Same problem does not occur.



NG
REPLACE COMPONENT WHICH HAS STORED THIS CODE
OK

END