STEERING PAD SWITCH > INSPECTION

for Preparation Click here



1. INSPECT STEERING PAD SWITCH RH


  1. Remove the steering pad switch LH connector with the steering pad switch RH and spiral cable still connected.


    E110590E01

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance 
    Tester Connection
    		Condition
    		Specified Condition
    DISP - EAU
    		DISP switch is not pushed in.
    		10 kΩ or higher
    DISP - EAU
    		DISP switch is pushed in.
    		Below 1Ω

    HINT:
    If the value is not as specified, replace the steering pad switch RH.