FRONT WIPER MOTOR > INSPECTION

for Preparation Click here



1. FRONT WINDSHIELD WIPER MOTOR ASSEMBLY (LHD STEERING POSITION TYPE)


    E034081E10

  1. LO Operation Check

    1. Connect the positive battery (+) lead to the terminal 1 (+1) of the connector and the negative battery (-) lead to terminals 5 (E) and check that the motor operates with low speed (LO).

  1. HI Operation Check

    1. Connect the positive battery (+) lead to the terminal 4 (+2) of the connector and the negative battery (-) lead to the terminal 5 (E) and check that the motor operates with high speed (HI).



    E068150E01

  1. Automatic Stop Operation Check

    1. Put the machmarks on the windshield wiper motor assembly.

    2. Connect the positive battery (+) lead to the terminal 1 (+1) of the connector and the negative battery (-) lead to the terminal 5 (E). With the motor being rotated at low speed (LO), disconnect the terminal 1 (+1) to stop the wiper motor operation at the position other than the match marks.

    3. Using SST, connect the terminal 1 (+1) and the terminal 3 (S), and the positive battery (+) lead to the terminal 2 (B) to restart the motor operation at low speed.

      SST
      09843-18040  

    4. Align the match marks with the wind shield wiper motor assembly.



2. FRONT WINDSHIELD WIPER MOTOR ASSEMBLY (RHD STEERING POSITION TYPE)


    E034081E11

  1. LO Operation Check

    1. Connect the positive battery (+) lead to the terminal 5 (+1) of the connector and the negative battery (-) lead to the terminal 4 (E) and check that the motor operates with low speed (LO).

  1. HI Operation Check

    1. Connect the positive battery (+) lead to the terminal 3 (+2) of the connector and the negative battery (-) lead to the terminal 4 (E) of the connector, and check that the motor operates with high speed (HI).



    E068151E01

  1. Automatic Stop Operation Check

    1. Put the match marks on the windshield wiper motor assembly.

    2. Connect the positive battery (+) lead to the terminal 5 (+1) of the connector and the negative battery (-) lead to the terminal 4 (E). With the motor being rotated at low speed (LO), disconnect the terminal 5 (+1) to stop the wiper motor operation at the position other than the match marks.

    3. Using SST, connect the terminal 5 (+1) and the terminal 1(S), and the positive battery (+) lead to the terminal 2 (B) to restart the motor operation at low speed.

      SST
      09843-18040  

    4. Align the match marks with the windshield wiper motor assembly.