RX400h · Service Manual RESTRAINTS

REMOVAL

Removal / installation

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.


1. PRECAUTION

CAUTION:
Be sure to read "PRECAUTION" thoroughly before servicing (Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent the airbag working.


3. REMOVE HEADLIGHT ASSEMBLY

  1. E068306
    Remove the 3 bolts.

  1. E068307
    Pull out the headlight assembly forward, then release the headlight bracket.

  1. E108643E01
    Disconnect each connector and separate the headlight assembly.

  1. Remove the clamp and headlight assembly.


4. REMOVE FRONT AIRBAG SENSOR LH

  1. H042704E01
    Remove the 2 bolts and the front airbag sensor LH.

  1. Disconnect the connector from the front airbag sensor LH.

← ON-VEHICLE INSPECTIONINSTALLATION →