INSTALLATION
Removal / installation
| 1. INSTALL WIRE HARNESS CLAMP BRACKET |
Install the wire harness clamp bracket with the 2 screws.
| 2. INSTALL ECM BRACKET NO.2 |
Install the ECM bracket No.2 with the 2 screws.
| 3. INSTALL ECM BRACKET NO.1 |
Install the ECM bracket No.1 with the 2 screws.
| 4. INSTALL HYBRID VEHICLE CONTROL ECU |
Install the hybrid vehicle control ECU with the 2 nuts.
- Torque:
- 5.5 N*m{ 56 kgf*cm , 49 in.*lbf }
Connect the 6 connectors to the hybrid vehicle control ECU.
Connect the 3 wire harness clamps.
| 5. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY |
Connect the connectors.
Install the 2 bolts <A>, the 2 screws <C>, and the glove compartment door assembly.
| 6. INSTALL INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO.2 |
Connect the connectors.
Engage the 3 claws and install the instrument panel No.2 under cover sub-assembly.
| 7. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH |
| 8. INSTALL FRONT DOOR SCUFF PLATE RH |
| 9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 10. PERFORM INITIALIZATION |