RX400h · Service Manual HYBRID SYSTEM

REMOVAL

Removal / installation


1. DISCONNECT CABLE FROM BATTERY NEGATIVE TERMINAL

2. REMOVE ENGINE ROOM SIDE LH COVER

  1. A108719
    Using a clip remover, remove the engine room side cover.


3. REMOVE AIR CLEANER CAP W/INLET

  1. A108124
    Remove the 2 bolts, 4 clamps and air cleaner cap w/ inlet.

  1. Remove the air cleaner filter element from the air cleaner case.


4. REMOVE CIRCUIT BREAKER SENSOR NO.1

  1. A108510E01
    Move the outer section to the wire harness side as illustrated, then disconnect the circuit breaker sensor No.1.

  1. A108507
    Remove the 2 bolts and circuit breaker sensor No.1 from the w/ converter inverter assembly.

← COMPONENTSINSPECTION →