FREEZE FRAME DATA
Troubleshooting
| FREEZE FRAME DATA |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position and check the freeze frame data by following the prompts on the intelligent tester screen.
Tilt & Telescopic: Item
Measurement Item/ Range (Display)
Normal Condition
Diagnostic Note
Tilt Position
Current tilt position data/min.: 0000 H (0 edge), max.: FFFF H (65535 edge)
7000 to 9000 H
(28672 to 36864 edge)
-
Telesco Position
Current telescopic position data/ min.: 0000 H (0 edge), max.: FFFF H (65535 edge)
7000 to 9000 H
(28672 to 36864 edge)
-
Up Switch
Communication state of tilt up input by manual switch/ON or OFF
ON: Tilt up is activated by manual switch
OFF: Tilt up is not activated by manual switch
-
Down Switch
Communication state of tilt down input by manual switch/ON or OFF
ON: Tilt down is activated by manual switch
OFF: Tilt down is not activated by manual switch
-
Short Switch
Communication state of telescopic short input by manual switch/ON or OFF
ON: Telescopic short is activated by manual switch
OFF: Telescopic short is not activated by manual switch
-
Long Switch
Communication state of telescopic long input by manual switch/ON or OFF
ON: Telescopic long is activated by manual switch
OFF: Telescopic long is not activated by manual switch
-
T&T Manual SW Data
Voltage data of manual switch/ min.: 0 V, max.: 5 V
Neutral position: Below 0.2 V
Tilt up: 1.67 to 2.13 V
Tilt down: 0.54 to 0.74 V
Telescopic contract: 1.08 to 1.40 V
Telescopic extend: 2.22 to 2.77 V
-
Power Source Voltage
Voltage data of power supply/min.: 0 V, max.: 20 V
Actual power supply voltage
10 to 14 V
-
Freeze Speed Info
Vehicle speed data/0 km/h (0 mph), max.: 255 km/h (158 mph)
Available only for vehicles with the freeze frame data
-
IG Switch (MPX)
Communication state of ignition switch/ON or OFF
ON: Communication is normal
OFF: Communication is interrupted
-
IG Switch
Input state of ignition switch/ON or OFF
ON: Input signal is normal
OFF: Input signal is interrupted
-
KEY Switch/MPX
Communication state of unlock warning switch/ON or OFF
ON: Communication is normal
OFF: Communication is interrupted
-
Receive from Body
Communication state of body ECU signal/OK or Interruption
OK: Communication is normal Interruption: Communication is interrupted
-
Receive from Seat ECU
Communication state of seat ECU signal/OK or Interruption
OK: Communication is normal Interruption: Communication is interrupted
-
Receive from Seat Combi
Communication state of combination switch ECU signal/OK or Interruption
OK: Communication is normal Interruption: Communication is interrupted
-
Receive from Meter
Communication state of combination meter signal/OK or Interruption
OK: Communication is normal Interruption: Communication is interrupted
-