C1210/36

DESCRIPTION

DTC No.	INF Code	DTC Detecting Condition	Trouble Area
C1210/36	336	Yaw rate sensor zero point calibration is unfinished.	Zero point calibration undone (Perform zero point calibration and check DTC. If DTC is not output again, the sensor is normal.) Yaw rate and deceleration sensor
C1336/98	318	Vehicle speed increases with unfinished zero point calibration. Zero point calculation is not within specified range when zero point calibration is finished.	Zero point calibration undone (Perform zero point calibration and check DTC. If DTC is not output again, the sensor is normal.) Yaw rate and deceleration sensor

INSPECTION PROCEDURE

1. PERFORM ZERO POINT CALIBRATION OF YAW RATE AND DECELERATION SENSOR

1. Perform the zero point calibration of the yaw rate and deceleration sensor. (Click here).

NEXT

2. RECONFIRM DTC

1. Clear the DTCs (Click here).

2. Turn the ignition switch on.

3. Check the same DTCs are recorded (Click here).
   

   Result:

   Condition	Proceed To
   DTC is not output	A
   DTC is output	B

B	REPLACE YAW RATE AND DECELERATION SENSOR

A
END