P0A94-545
Diagnostic trouble codes
DESCRIPTION
Refer to the description of the boost converter. (Click here)If the boost converter detects a circuit malfunction or overvoltage, it transmits this information to the OVL terminal of the MG ECU via the boost converter overvoltage signal line. The MG ECU monitors the boost converter overvoltage signal line and detects a malfunction.
| DTC No. |
INF Code |
DTC Detection Condition |
Trouble Area |
| P0A94 |
545 |
Open or GND short in boost converter overvoltage (OVL) signal line |
|
| ↑ |
546 |
+B short in boost converter overvoltage (OVL) signal line |
|
MONITOR DESCRIPTION
The MG ECU monitors the boost converter over-voltage (OVL) signal line. If the MG ECU detects an open or short malfunction of the OVL signal circuit, the HV control ECU illuminates the MIL and sets a DTC.INSPECTION PROCEDURE
- CAUTION:
- Before inspecting the high-voltage system, take safety precautions to prevent electrical shocks, such as wearing insulated gloves and removing the service plug grip. After removing the service plug grip, put it in your pocket to prevent other technicians from reconnecting it while you are working on the high-voltage system.
- After disconnecting the service plug grip, wait for at least 5 minutes before touching any of the high-voltage connectors or terminals.
- Before inspecting the high-voltage system, take safety precautions to prevent electrical shocks, such as wearing insulated gloves and removing the service plug grip. After removing the service plug grip, put it in your pocket to prevent other technicians from reconnecting it while you are working on the high-voltage system.
- HINT:
- At least 5 minutes is required to discharge the high-voltage capacitor inside the w/ converter inverter assembly.
| 1. CHECK CONNECTION CONDITION OF MG ECU CONNECTOR (LOOSENESS AND POOR CONTACT) |
- CAUTION:
- Be sure to wear insulated gloves.
Turn the ignition switch off and remove the service plug grip. (Click here)
- NOTICE:
- Do not put the vehicle into the READY-on state with the service plug grip removed as this may cause a malfunction.
Remove the inverter cover. (Click here)
- NOTICE:
- Wrap the interlock round terminal for the inverter cover with vinyl tape to prevent it from shorting to ground.
- Prevent water in the reservoir tank from entering the inverter.
- Removing the inverter cover causes the MG ECU board to be exposed. Therefore, temporarily install the inverter cover for each area to be inspected.
- Wrap the interlock round terminal for the inverter cover with vinyl tape to prevent it from shorting to ground.
Check the connections of the MG ECU connectors.
- OK:
- Connectors are connected securely and there is no poor connection.
|
|
||||
| OK | ||
 |
||
| ||