REASSEMBLY
Removal / installation
| 1. INSTALL COOLER DRYER |
Using needle nose pliers, install the cooler dryer.
Install a new O-ring to the cap.
Sufficiently apply compressor oil to the fitting surfaces of the O-ring and the cap.
- Compressor oil:
- ND-OIL 11 or equivalent
- NOTICE:
- Do not use any compressor oil other than ND-OIL 11 or equivalent.
- If any compressor oil other than ND-OIL 11 or equivalent is used, compressor motor insulation performance may decrease, resulting in leakage of electric power.
- Do not use any compressor oil other than ND-OIL 11 or equivalent.
Using hexagon wrench 14 mm, install the cap to the cooler condenser assembly.
- Torque:
- 2.9 N*m{ 30 kgf*cm , 25 in.*lbf }