RX400h · Service Manual HEATER & AIR CONDITIONING SYSTEM

INSTALLATION

Removal / installation


1. INSTALL AIR CONDITIONER AMPLIFIER ASSEMBLY

  1. I036008
    Install the air conditioner amplifier assembly with the 2 nuts.


2. INSTALL HYBRID VEHICLE CONTROL ECU

  1. Install the hybrid vehicle control ECU with the 2 nuts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

  1. Connect the 6 connectors to the hybrid vehicle control ECU.

  1. Connect the 3 wire harness clamps.


3. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY

  1. B108513E03
    Connect the connectors.

  1. Install the 2 bolts <A>, the 2 screws <C>, and the glove compartment door assembly.


4. INSTALL INSTRUMENT PANEL UNDER COVER NO.2 SUB-ASSEMBLY

  1. B112171
    Connect the connectors.

  1. Engage the 3 claws and install the instrument panel No.2 under cover sub-assembly.


5. INSTALL COWL SIDE TRIM RH SUB-ASSEMBLY

6. INSTALL FRONT DOOR SCUFF PLATE RH

7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

8. PERFORM INITIALIZATION

NOTICE:
Some systems need initialization when disconnecting the cable from the negative battery terminal. (Click here)

← REMOVALPRECAUTION →