INSPECTION

1. Secure the front stabilizer link assembly in a vise using aluminum plates.
   

2. Install the nut to the front stabilizer link assembly stud.
   

3. Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the 5th turn.
   

   Turning torque:

   2.0 N*m (20 kgf*cm, 18 in.*lbf) or less
   

   HINT:

   If the turning torque is greater than the specified range, replace the front stabilizer link assembly with a new one.

Inspect the dust cover.

1. Check that there are no cracks and grease on the dust cover.