Multi-display Power Source Circuit
Circuit diagnosis
DESCRIPTION
This is the power source circuit to operate the multi-display.WIRING DIAGRAM
INSPECTION PROCEDURE
| 1. INSPECT MULTI-DISPLAY |
Disconnect the multi-display connectors M4 and M1.
Measure the resistance according to the value(s) in the table below.
- Resistance:
Tester connection
Condition
Specified condition
GND (M1-3) - Body ground
Always
Below 1 Ω
GND (M4-3) - Body ground
Always
Below 1 Ω
Measure the voltage according to the value(s) in the table below.
- Voltage:
Tester connection
Condition
Specified condition
+B1 - GND
Always
10 to 14 V
ACC - GND
Ignition SW ACC
10 to 14 V
IG - GND
Ignition SW ON
10 to 14 V
|
|
||||
| OK | ||
 |
||
| ||