RX400h · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation


1. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH

  1. Remove the 2 nuts and the front wiper arm and blade assembly RH.


2. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH

  1. Remove the nut and the front wiper arm and blade assembly LH.


3. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY

  1. E110470
    Remove the 2 clips.

  1. Disengage the 6 claws and the clamp, and remove the cowl top ventilator louver sub-assembly.


4. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

  1. E110471E01
    Disconnect the connector.

  1. Remove the 5 bolts and the windshield wiper motor and link assembly.

    HINT:
    Bolt <A> cannot be removed because it is integrated into windshield wiper link assembly.


5. REMOVE FRONT WIPER MOTOR

  1. I035808E01
    Using a screwdriver wrapped with protective tape, separate the rod of the windshield wiper link assembly from the front wiper motor as shown in the illustration.

  1. I035809E01
    Remove the nut and washer.

  1. Put the matchmarks on the crank arm and front wiper motor.

  1. I035810
    Remove the 3 bolts and front wiper motor from the windshield wiper link assembly.

← ON-VEHICLE INSPECTIONINSPECTION →