DATA LIST / ACTIVE TEST
System information
| READ DATA LIST |
- HINT:
- Using the intelligent tester's DATA LIST allows switch, actuator and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to save time.
Connect the intelligent tester with CAN VIM to the DLC3.
Turn the ignition switch to the ON position.
Read the DATA LIST.
Power back door ECU Item
Measurement Item /
Display (Range)
Normal Condition
Diagnostic Note
Courtesy SW
Back door lock courtesy switch signal
/OFF or ON
OFF: Back door is closed
ON: Back door is open
-
Half Latch* SW
Back door lock half-latch* switch signal
/OFF or ON
OFF: Back door is closed
ON: Back door is not completely closed
-
Back Door Handle SW
Back door opener switch (outside handle) signal
/OFF or ON
OFF: Back door opener switch is not pushed
ON: Back door opener switch is pushed
-
- HINT:
- *: RATCHET appears on the display of the intelligent tester, however, the name of the part corresponding to the display of the tester is "half-latch".
Body ECU Item
Measurement Item /
Display (Range)
Normal Condition
Normal Condition
Back DOR Open
Back door open judgement
/PROHIBIT or PERMIT
PROHIBIT: Back door is in LOCK position (prohibited from being unlatched)
PERMIT: Back door is in UNLOCK position (permitted to be unlatched)
-
B Doe Oper SW
Power back door opener/closer switch signal
/ON or OFF
ON: Power back door opener/closer switch is pushed
OFF: Power back door opener/closer switch is not pushed
-
Multiplex network master switch assembly (Driver door ECU) Item
Measurement Item /
Display (Range)
Normal Condition
Diagnostic Note
Door Unlock Detection SW
Door unlock detection switch signal
/ON or OFF
ON: Any door is unlocked
OFF: All doors are locked
-
| PERFORM ACTIVE TEST |
- HINT:
- Performing the intelligent tester's ACTIVE TEST allows relay, VSV, actuator, and other items to be operated without removing any parts. Performing the ACTIVE TEST early in troubleshooting is one way to save time. The DATA LIST can be displayed during the ACTIVE TEST.
Connect the intelligent tester with CAN VIM to the DLC3.
Turn the ignition switch to the ON position.
Perform the ACTIVE TEST.
Power back door ECU Item
Test Details
Diagnostic Note
Latch Release
Back door lock latch release
OFF/ON
-
Courtesy SW Signal
Back door courtesy switch
OFF/ON
Command signal from tester is prior to that from back door courtesy switch when these 2 signals occur at the same time.