Front Passenger Side Power Window Motor Circuit

DESCRIPTION

This circuit transmits signals from the multiplex network switch to power window regulator motor.

WIRING DIAGRAM

INSPECTION PROCEDURE

1. INSPECT POWER WINDOW REGULATOR MOTOR

1. Remove the power window motor.

2. Apply battery voltage to the motor connector according to the table below.

   NOTICE:

   Do not apply battery to any terminals except terminals 1 and 2.

   Standard:

   Measurement Condition	Specified Condition
   Battery positive (+) → Terminal 1 (D) Battery negative (-) → Terminal 2 (U)	Motor gear rotates counterclockwise
   Battery positive (+) → Terminal 2 (U) Battery negative (-) → Terminal 1 (D)	Motor gear rotates clockwise

NG	REPLACE POWER WINDOW REGULATOR MOTOR

OK

2. CHECK WIRE HARNESS (WINDOW REGULATOR MOTOR - MULTIPLEX NETWORK SWITCH)

1. Disconnect the P15 (P16) and P20 (P21) connectors.

2. Measure the resistance according to the value(s) in the table below.
   

   Standard resistance:

   RHD Models:

   Tester Connection	Condition	Specified Condition
   P15-1 (DN) - P20-1 (D)	Always	Below 1 Ω
   P15-6 (UP) - P20-2 (U)	Always	Below 1 Ω
   P15-1 (DN) - Body ground	Always	10 kΩ or higher
   P15-6 (UP) - Body ground	Always	10 kΩ or higher

   LHD Models:

   Tester Connection	Condition	Specified Condition
   P16-1 (DN) - P21-1 (D)	Always	Below 1 Ω
   P16-6 (UP) - P21-2 (U)	Always	Below 1 Ω
   P16-1 (DN) - Body ground	Always	10 kΩ or higher
   P16-6 (UP) - Body ground	Always	10 kΩ or higher

NG	REPAIR OR REPLACE HARNESS OR CONNECTOR

OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE