INSPECTION

1. Select "L" on the left/right adjustment switch.
   

2. Measure the resistance according to the value(s) in the table below when the switch is operated.
   

   Standard resistance:

   Tester Connection	Switch Position	Specified Condition
   2 - 3	OFF	10 kΩ or higher
   	UP	225 to 275 Ω
   	DOWN	437 to 503 Ω
   	LEFT	744 to 856 Ω
   	RIGHT	437 to 503 Ω
   1 - 2	L	90 to 110 Ω
   	R	10 Ω or less

Inspect the retract switch operation.

1. Measure the resistance according to the value(s) in the table below when the switch is operated.
   

   Standard resistance:

   Tester Connection	Switch Position	Specified Condition
   4 - 7	OFF	10 kΩ or higher
   	ON	Below 1 Ω

1. Select "L" on the left/right adjustment switch.
   

2. Measure the resistance according to the value(s) in the table below when the switch is operated.
   
   

   Standard resistance:

   Select "L" on the left/right adjustment switch:

   Tester Connection	Switch Position	Specified Condition
   4 - 8	UP	Below 1 Ω
   6 - 7
   4 - 7	DOWN
   6 - 8
   5 - 8	LEFT
   6 - 7
   5 - 7	RIGHT
   6 - 8

   Select "R" on the left/right adjustment switch:

   Tester Connection	Switch Position	Specified Condition
   3 - 8	UP	Below 1 Ω
   6 - 7
   3 - 7	DOWN
   6 - 8
   2 - 8	LEFT
   6 - 7
   2 - 7	RIGHT
   6 - 8

Inspect the retract switch operation.

1. Measure the resistance according to the value(s) in the table below when the switch is operated.
   

   Standard resistance:

   Tester Connection	Switch Position	Specified Condition
   7 - 9 8 - 10	OFF	Below 1 Ω
   7 - 10 8 - 9	ON