Rear Double Lock Motor RH Circuit

DESCRIPTION

The rear right side door double lock motor is built into the rear right side door lock assembly.
The door opening relay receives rear right side door double door lock set/release signals from the body ECU using multiplex communication.
The door opening relay controls the double lock motor to set/release the double door lock. This relay applies current from terminal ACTS to terminal ACTR to operate the motor to set the lock. It reverses the direction of the current to operate the motor to release the lock.

WIRING DIAGRAM

1. INSPECT REAR DOOR LOCK ASSEMBLY RH (DOUBLE LOCK MOTOR)

1. Remove the rear door lock assembly RH.

2. Apply battery voltage and set the door lock motor to the lock position.

   OK:

   Measurement Condition	Specified Condition
   Battery positive (+) →Terminal 4 Battery negative (-) →Terminal 3	Lock

3. Apply battery voltage to the door lock and check operation of the double lock motor.

   OK:

   Measurement Condition	Specified Condition
   Battery positive (+) →Terminal 2 Battery negative (-) →Terminal 1	Double Locking System is Set
   Battery positive (+) →Terminal 1 Battery negative (-) →Terminal 2	Double Locking System is Unset

4. Check that the doors cannot be unlocked by operating the control cable while the double locking system is set.

NG	REPLACE REAR DOOR LOCK ASSEMBLY RH

OK

2. CHECK WIRE HARNESS (REAR DOOR LOCK ASSEMBLY RH - DOOR OPENING RELAY ASSEMBLY)

1. Disconnect the rear door lock assembly RH connector.

2. Disconnect the door opening relay assembly connector.

3. Measure the resistance according to the value(s) in the table below.

   Standard resistance:

   Tester Connection	Condition	Specified Condition
   D15-2 (DL) - D2-3 (ACTS)	Always	Below 1 Ω
   D15-1 (UNDL) - D2-4 (ACTR)	Always	Below 1 Ω

NG	REPAIR OR REPLACE HARNESS OR CONNECTOR

OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE