REPLACEMENT
Removal / installation
| 1. REMOVE REAR WHEEL |
| 2. REMOVE REAR DISC BRAKE CALIPER ASSEMBLY |
Remove the 2 bolts and separate rear disc brake caliper assembly.
- NOTICE:
- Use a string or other device to keep the brake caliper from hanging down.
| 3. REMOVE REAR DISC |
Put matchmarks on the rear disc and the axle hub.
Release the parking brake, and remove the rear disc.
- HINT:
- If the disc cannot be removed easily, turn and press firmly the shoe adjuster until the wheel comes free.
| 4. REMOVE REAR AXLE HUB BOLT |
Temporarily install the 2 nuts and washers to the rear axle hub bolt as shown in the illustration.
- SST
- 09628-10011
Using SST and a brass bar or an equivalent to hold the hub and bearing assembly, remove the rear axle hub bolt.
| 5. INSTALL REAR AXLE HUB BOLT |
Install a washer and nut to a new bolt, as shown in the illustration.
Using a brass bar or an equivalent to hold the hub and bearing assembly, install the rear axle hub bolt by tightening the nut.
| 6. INSTALL REAR DISC |
Aligning the matchmarks, install the rear disc.
- HINT:
- When replacing the rear disc with a new one, select the installation position where the rear disc has the minimum runout.
| 7. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY |
Install the rear disc brake caliper assembly with the 2 bolts to the rear axle carrier.
- Torque:
- 78 N*m{ 795 kgf*cm , 58 ft.*lbf }
| 8. INSTALL REAR WHEEL |
- Torque:
- 103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }